Good day , This thread has become inactive for more than 60 times. New postings Allow me to share not likely to be noticed or responded to by other customers. For far better visibility, think about Starting up A brand new Thread.
For a wealth of pool care information and facts make sure you consider our no cost Pool University. Should you be in need of unique support then we motivate you to definitely Sign up and request us in this article within the Discussion board!
Any Suggestions as checked the jumper, did the black, inexperienced an yellow link as pink isn't useful for some reason. Tackle is one like the pump.
Another thing to remember is always that pump run time won't avoid algae, only sustaining a proper chlorine degree can do that.
If grime and oils are included you must take away All those to start with with a little something alkaline (Imagine degreaser/surfactant (like your purge product) then use acid for mineral scale.
Also you should definitely have some sanitizer in the h2o considering the fact that you might want to contact the drinking water to clean (i would go slam stage) Click to broaden...
Nov 7, 2024 Incorporate bookmark #14 effectively a tech arrived out and it is a negative higher board wherever the Serial port sits. Negative out of the box! Now working on a whole new MasterTemp heater set up that doesn't want to speak in any way to my Intellitouch.
Dec 1, 2024 Incorporate bookmark #eighteen Alright, Far more fascinating data. Fooling around with all of the comm connections and located out this. Pump gartenpool will shut down after 1 min when the info relationship is lost and lightweight goes purple to eco-friendly. Requires about 5 seconds to go purple on reconnection. So I disconnected all comms besides the pump and property relationship to Pentair Screenlogic with automation connection. The Pump shut down, relationship mild stayed green and pump would not switch back again onwith only Screenlogic and pump linked on primary board. I unplugged the automation serial adapter and pump reconnected and started.
I'll put up these tomorrow. My Youngsters couldn't think the primary difference. Many thanks for all of the enter. I could only uncover Metal Free of charge to make use of to be a sequestrant.
It was super foamy throughout the 1st purge. Not as much 2nd time about if the phony tan arrived out on the pipework. Been utilizing gloves.
To depart my pump / filter operating all night time - all I needed to do is convey to my Electrical Company my checking account and routing number and the way to access my retirement discounts...
Need to have much more detailed data? Check out the wiki! We have compiled information on various Superior subject areas in pool care. Watch the Wiki
The factor inside the Photograph -- I key it and then start off my filter. It fills up but almost always has bubbles in it.
I flipped the breaker and Lower off electrical power for a few minutes and turned it all back again on and every thing was cleared. I ran the heater for a few minutes and no challenges.
Hello there , This thread has long been inactive for more than sixty days. New postings Listed below are unlikely for being observed or responded to by other associates. For much better visibility, contemplate Commencing A fresh Thread.